AMP-2P 30mg

Description

Our AMP-2P 30mg vial holds 30mg of lyophilized AMP-2P (tirzepatide), a dual GIP and GLP-1 receptor agonist. It’s for in-vitro and lab research only.

What is AMP-2P (tirzepatide)?

Tirzepatide is a 39-amino-acid peptide from Eli Lilly that activates two receptors, GIP and GLP-1. A fatty acid side chain lets it bind albumin, so its half-life is about five days. It’s approved as Mounjaro for type 2 diabetes and as Zepbound for weight management.

How AMP-2P acts in the lab

Tirzepatide activates two incretin receptors. GIP and GLP-1 are both released by the gut after eating, and both push the pancreas to release insulin when glucose is high. GLP-1 also slows stomach emptying and acts on appetite centers in the brain.

The molecule is built on the GIP sequence and tuned to hit the GLP-1 receptor as well. It leans toward GIP in binding strength. A C20 fatty diacid lets it ride on albumin, so it lasts days instead of minutes.

AMP-2P 30mg specifications

• Compound: AMP-2P (tirzepatide)
• Also known as: LY3298176
• CAS number: 2023788-19-2
• Molecular formula: C225H348N48O68
• Molar mass: 4,813.5 g/mol
• Structure: 39 amino acids with a C20 fatty diacid side chain
• Amount: 30mg per vial
• Form: lyophilized (freeze-dried) powder
• Purity: 99% or higher (HPLC)
• SKU: AMP-2P-30
• Use: laboratory research only

AMP-2P research

The SURMOUNT-1 trial (New England Journal of Medicine, 2022) reported average weight loss of up to about 21% over 72 weeks at the highest dose. The SURPASS trials covered blood sugar control in type 2 diabetes.

The primary literature is on PubMed. Here’s a search for tirzepatide studies to start from.

AMP-2P 30mg reconstitution and concentration

Here’s the math for 30mg of peptide:

• 2mL of diluent gives 15mg/mL
• 3mL of diluent gives 10mg/mL
• 5mL of diluent gives 6mg/mL

Choose the volume that suits your measurements. Mark the vial with the concentration and date so nobody has to guess later.

Research diluent solution or bacteriostatic water both work. Add it slowly so it runs down the side of the vial, then swirl or roll until everything dissolves. Shaking can shear peptide chains. Skip it.

Storing AMP-2P 30mg

Store sealed vials in the fridge (2 to 8°C) or freezer (-20°C), away from light. Mixed solution goes back in the fridge and should be used within about 28 days.

AMP-2P 30mg quality and batch records

Every batch of AMP-2P 30mg is made to a minimum of 99% purity by HPLC.

The label on every vial shows the compound, the amount and the batch. Ask us for the certificate of analysis for your batch and we’ll email it over, which is handy if your lab keeps paperwork on file.

Write the batch number in your lab notes when you open a new vial. If you ever need to compare results between orders, that’s the detail you’ll want.

What you need with AMP-2P 30mg

Check you have everything before the vial arrives: a sterile diluent such as our research diluent solution, sterile syringes, alcohol swabs and room in the fridge. Our vial case holds ten vials upright, and the vial opener pops flip-off caps cleanly.

AMP-2P 30mg bulk pricing

Buying for a longer project? AMP-2P 30mg is available in these quantities:

• Single vial: $58.00
• 5 pack: 5 vials for $261.00 instead of $290.00, about $52.20 a vial
• 10 pack: 10 vials for $493.00 instead of $580.00, about $49.30 a vial

The packs are the same vials as the single listing, just priced lower per vial. If you know you’ll go through more than four, the 5 pack already costs less than buying them one by one.

AMP-2P sizes compared

• AMP-2P 10mg: 10mg for $29.00, about $2.90 per mg
• AMP-2P 15mg: 15mg for $43.00, about $2.87 per mg
• AMP-2P 20mg: 20mg for $51.00, about $2.55 per mg
• AMP-2P 30mg (this page): 30mg for $58.00, about $1.93 per mg
• AMP-2P 60mg: 60mg for $91.00, about $1.52 per mg

AMP-2P 30mg sits in the middle of the range: more material than the small vial without the upfront cost of the largest.

Compounds often ordered with AMP-2P

• Cagrilintide 10mg, an amylin analog
• Survodutide 10mg, a GLP-1/glucagon agonist
• AMP-3P 24mg, a triple agonist
• Eloralintide 10mg, an amylin agonist
• AMP-1P 10mg, a GLP-1 agonist

Browse the full GLP-1 peptides and weight loss peptides range, or see everything on our research peptides page.

AMP-2P 30mg FAQ

How much is in the AMP-2P 30mg vial?

30mg of lyophilized powder. The amount is printed on the label.

Is there a discount for buying more?

Yes. The 5 pack saves 10% and the 10 pack saves 15% compared with buying single vials. Pick the option from the dropdown on this page.

Is there a COA for AMP-2P 30mg?

Yes. Each batch has a certificate of analysis filed under the batch number on the label. Email us that number and we’ll send it.

What do I mix AMP-2P 30mg with?

A sterile diluent such as our research diluent solution or bacteriostatic water. The reconstitution section above shows the concentration for each volume.

How should I store it?

Sealed vials go in the fridge, or the freezer for long-term storage. Once mixed, refrigerate and use within about 28 days.

Buy AMP-2P 30mg online

Ready to order? AMP-2P 30mg costs $58.00 and is in stock. Add it to your cart and you’re done. Add a research diluent solution if you don’t have any, so you’re ready to reconstitute when it arrives.

Need more for the same project? See the rest of our GLP-1 peptides and weight loss peptides.

For laboratory research use only. Not for human or veterinary use. Not evaluated by the FDA.